How do I setup my Tenda N300 range extender / Wifi Router?

Follow these steps -:

1.1 Make sure the router is placed as close as possible to the nearest Access Point i.e. where you normally get the strongest “AcceleritWireless” signal in your house / apartment / room. This is normally where our installer initially places your router.

1.2 Assuming you have already rest the router – Connect to it by scanning for SSID “Tenda_XXX” You will see this when you scan for available Wi-Fi networks on your device. Note that the “XXX” may be a number in your scenario.

2. Connect and navigate to “192.168.0.1” on your internet browser – When you see the Tenda login screen enter “admin” for username and “admin” for password.

Login

3. Once done click on “Advanced Settings” on the top right of the screen.
Advanced
4. Click on “Wireless” and then “Wireless Security” and choose a password for “TENDA_XXX”

WirelessSecurity5. You will be logged off and at this point you should reconnect your device to “TENDA_XXX”

6. Again click on “Advanced settings” once you’ve logged on to the range extender admin page. You must enter 192.168.0.1 browser address bar to get to the admin page should you not be redirected automatically.

7. Click range extender and choose “WISP”

8. Click on open scan and look for “AcceleritWireless” with the lowest number associated with it under “Signal Strength”.

WirelessWISP9. Click on connect and that’s it! You should be redirected to our login screen after your router reboots.

Comments are closed.